|
10,000 Watt, High Voltage (380Vdc), Single Output, Commercial Grade Power Supply
Product Description
This unit is a 10,000 watt, high voltage (380Vdc), single output, commercial grade power supply designed for electronic systems utilizing higher voltage DC. It is fan cooled providing for a 0° to +50° C operating temperature range. This highly reliable design provides a non-isolated, fixed 380Vdc output. This 10kW high voltage unit can be configured for N+1 hot swap applications and offers input voltage options to accommodate 240 or 480Vac 3-phase, input.
Product Features
- Output Voltage: 380Vdc
- Input Options: 208/240 or 480Vac, 3 Phase
- Size: 5” x 5” x 16.5”
- Power Factor Correction: 0.99 @ Full Load (.95 for 3 Phase)
- Operating Temp. Range 0° to +50° C (at Full Load)
- No Minimum Load Required
General Specifications
- Regulation: ±0.25% (Line and Load)
- Ripple and Noise: 15V peak (10Khz to 100Khz bandwidth)
- Efficiency: Typical 90% at 80% Load for 240Vac Input
- OVP, Over Current & Over Temperature Protection
- Fully Protected Output, Up to 1500 Watts
- Safety Agencies: Designed to met UL, CSA and TUV to EN60950-1
- EMI: Designed to meet conducted and radiated EN55022 Level A
| Model #: |
Voltage |
Max Current |
|
PM35220B-5P
|
380Vdc
|
26.3 Amps
|
Note: Alternate output voltages are available, consult factory for availability.
Output Conditions
Initial Output Load Conditions: No load should be applied during initial AC start-up. This power supply is configured with two PFC modules. The power supply is designed to provide output power as follows: 10000W @ 380VDC - Load Enable signal is provided on J1. Pin 1 is load enable and pin 2 is logic return. The signal is driven by an opto-coupler. When opto-transistor is OFF (high impedance) the load is to be disabled. When opto-transistor is ON (low impedance) the load is to be enabled.
Product Options
- Inhibit – Enable/Disable
- AC Fail with LED Indicator
- DC Output Good with LED Indicator
- Constant Current Limit
- Isolation Diodes
- Current Monitor
- Single Wire Current Sharing
- ±10% Output voltage swing
- Power Supply Fail with LED Indicator
- Single Wire/Droop Current Sharing
|
Design Services
